1) Question: are Honda vtx 1300 r and 1800r kickstands interchangeable ?
Answers:
|
2) Question: We have a 1998 Polaris xplorer 400 4x4 and we are looking for the
right (if you are sitting on the bike) footwell and cannot locate one
is there any place you know of that we could get one from
Answers:
|
3) Question: Hello, my speedometer stopped working, i checked the cable, and it is
good not broken, when i spin it by hand, the speed display moves, so
it is the gear sprocket assembly on the wheel hub. would you have the
part.?
Answers:
|
4) Question: 2006 Yamaha xvs-1100 classic silverado. Cranks but will not start.
Have cked fuses (ok), getting fuel, Suspect no spark. Need steps to
diagnose suspected part and or known issues regarding most common part
failure.
Answers:
|
5) Question: i have a 1984 kawasaki tecate 250 3 wheeler. What is the voltage
suppose to be coming out of the stator going to the ignitor box?
Answers:
|
6) Question: Will a 1974 yamaha dt 250 gauges (speedo/tach)be compatible w/1975 Dt
400??
Answers:
|
7) Question: to replace oil pump does the engine case need to be splite open
Answers:
|
8) Question: my 82 yamaha 750 maxim has lots of issues but it runs pretty good all
but for when at idle it sometimes revs high but usually I have to give
it gas because it will idle down and even die .It restarts easily and
as long as you're moving its powerful and runs great. Could this be
dirty floats and needles or do I need the carbs rebuilt?Timing
Thing?Naaah because of the low idle probably carbs.please help out
with any tips.
Answers:
|
9) Question: I'm looking for a fuel tank that will bolt on a 1987 Honda Rebel
450cc. Would like an original tank if one is available somewhere, but
it Doesn't matter what aftermarket type tank as long as it will bolt
on and hook up without any modifications.
Answers:
|
10) Question: Does any one build a custom air dam for a early model Valkyier?
Answers:
|
11) Question: scanner diagnosis revealed P1165 swirl control valve:control vacuum
switch, can this cause increased fuel consumption
Answers:
|
12) Question: I have a 1982 xt 250 minus engine/gearbox , was wondering if anyone
could tell me if a 500 or 550 engine out of a 1982 xt can fit in the
frame without major mods . Or should I just keep looking for a 250 of
the same year? I haven't had much luck finding dimensions for engine
mounting comparisons. Any help would be appreciated. Thanks
Answers:
|
13) Question: I have a Yamaha majesty 400 and I need to find a cheap place to find
parts. I live in Baltimore Maryland,can you help?
Answers:
|
14) Question: I have a 1997 GSXR 750 and i would like to do a newer motor swap. I
have seen a couple bikes with a 2003- 2005 GSXR 750 engine. Is the
motor swap a direct bolt or are there a bunch of mods needed?
Answers:
|
15) Question: what is the largest number teeth sprocket for the rear available? for
an 2007 KLR 650
the smallest number teeth counter sprocket on KLR650 2007
Answers:
| |
call to order new sprockets discounted
Call 1-785-242-0600 9am-6pm Tues-Sat
(central Time)
to purchase this item. OZ Powersports is the National
Leader is
cycle/atv salvage with over 50,000 units in
inventory. Shop us online at
www.ozpowersports.com
for all your new parts/accessories needs.We look
foward
to hearing from you! - OZ Powersports
|
|
Next